Rage Powersport Black Widow Motorcycle Lift Table

Not as good as it sounds....

Strengths: The table itself is well made. No complaints there.

Weakness: The wheel vise is awkward and doesn't clamp as securely as I'd like when my bike is up in the air. Handle to move stand broke 1st time. The vise handle is a POS. Stripped immediately.

The table surface is great. Pull out plate for servicing real wheel is good. I purchased the 10" sides and the supports, side extensions, and additional ramp sections were as good as the table itself. That as far as the good stuff goes.The vise itself was awkward. More or less have to slide the vise arms to the tire and then crank the vise tight. The vise handle stripped while trying to...
Read Full Review

The table surface is great. Pull out plate for servicing real wheel is good. I purchased the 10" sides and the supports, side extensions, and additional ramp sections were as good as the table itself. That as far as the good stuff goes.The vise itself was awkward. More or less have to slide the vise arms to the tire and then crank the vise tight. The vise handle stripped while trying to tighten the arms. Had to use channel locks to tighten vise from there on. They show pads for the inner vise arms but I didn't receive any. cut some sections of thick truck mud flaps to attach so they didn't mar the rims.The Arm/Lever they give you to move the table was a joke. At the end of the arm, there are two wheels and a hole in the tube. You allow a finger attached to the end of the table to fall into that hole and then tilt the arm downward to lift the table and allow the wheels to meet the floor. Well, it bent it half and broke. Lever should have been made solid rather than the hollow way they chose.Another downside is that should a part break or be MIA, there's noway to order replacement parts from the manufacturer.

By anonymous; - Apr 24, 2013